| |
How It Works
|
| Skeet-R-Gone |
| |
| Liquid concentrate is injected into an existing sprinkler system by a 160 PSI pump
that is housed in an exterior enclosure. This enclosure also houses the concentrate. |
|
| |
Click to see larger image
|
| |
|
|
|
The concentrate is pumped through a small tube that connects to a special mixing
chamber and saddle valve. These are installed directly onto the water supply after the backflow preventer. |
|
Click to see larger image
|
|
| |
|
| The pump is controlled by a wiring harness that leads to the Skeet-R-Gone controller,
which is mounted next to the sprinkler system control panel. |
| |
|
|
|
|
Click to see larger image
|
| |
|
 |
| |
Simple to Operate
|
| |
|
|
| |
| 1 |
|
Replace primer bottle with desired concentrate in the exterior enclosure. |
| |
|
|
| 2 |
|
Manually activate a zone. |
| |
|
|
| 3 |
|
Push red activation button on Skeet-R-Gone controller for pre-determined number of
seconds, then release. |
| |
|
|
| 4 |
|
Allow zone to run for an additional one minute (30 seconds to mix & distribute
concentrate and 30 seconds to flush the zone), then deactivate zone. |
| |
|
|
| 5 |
|
Repeat activation steps for each zone. |
| |
|
|
| 6 |
|
Replace concentrate with primer bottle. *
* This step is necessary because the Skeet-R-Gone controller will not operate
pump without primer. |
| |
|
|
|
| |
|
